Accessorial charges are the fees a carrier bills on top of linehaul and fuel for extra time or work on a load. On truckload invoices the common ones are detention, lumper, TONU, and layover. Each one is a claim that something happened on the load, so you pay it when the evidence on the load backs it up.
Finding that evidence is the slow part. Someone opens the TMS for stop times and digs the lumper receipt out of an email, then waits on the rep to say whether a TONU was real. A FlowRunner flow does the lookups on every invoice, clears the charges the evidence proves, and asks the rep only about the ones it can’t.
- 1Invoice arrivesA PDF in your carrier invoice inbox
- 2Agent reads itEach extra charge, the receipts, the rate con terms
- 3Evidence checkedStop times and documents on the load
- 4The rep decidesOnly the charges with no proof
- 5Bill createdWith the evidence for each charge
One invoice with three accessorials, start to finish
Here is a sample invoice from Bluebonnet Freight Lines for a reefer load from Salinas, CA to a grocery warehouse in Phoenix, AZ. The flow read the PDF and the lumper receipt attached to the email. It found the load in Turvo, pulled the stop times, and read the rate confirmation on the load for its accessorial terms. Detention starts after 2 hours, counted from the later of arrival or appointment, at $70 an hour. Lumpers are paid at cost with a receipt.
| Charge | Evidence the flow found | Invoice |
|---|---|---|
| Linehaul and fuel | Rate con: $3,100.00 and $520.00 | $3,620.00 |
| Detention, 2.5 hours at $70 | Turvo, Nov 6: appointment 6:00 AM, arrived 5:52 AM, departed 10:30 AM | $175.00 |
| 4 hours 30 minutes from the appointment to departure, less 2 hours free, is 2.5 hours at $70. Matches the hours billed. | ||
| Lumper | Receipt R-40917 attached to the email, $245.00 | $245.00 |
| The receipt is dated Nov 6 at the Phoenix delivery and shows the load number and the same amount. | ||
| TONU, Nov 4 | No cancellation on the load | $200.00 |
| The load has one pickup, on Nov 5, and the truck loaded on time. Nothing on the load says a truck was turned away on Nov 4. | ||
| Total | $4,240.00 | |
Detention and the lumper clear on their own. The TONU has nothing behind it in the system, so the flow holds that line and asks Ana, the rep who covered the load, in Slack:
Slack, direct message to the rep on the load
TONU with no cancellation: Bluebonnet Freight Lines, load 51904-22816
Invoice 7731 bills a $200.00 TONU for Nov 4. The load shows one pickup, Nov 5. Detention ($175.00) and the lumper ($245.00) are proven and ready to pay.
What does the carrier say happened on Nov 4?
Their email says the driver reached the shipper at 7:10 AM on Nov 4 and was sent away because the load wasn't ready. The rate confirmation sets pickup for Nov 5 at 7:00 AM, and Turvo shows the truck arrived 6:48 AM that day.
Ana knows the pickup was always booked for Nov 5 and the carrier sent a truck a day early, so Ana clicks Dispute. The flow replies in the carrier’s email thread with the booked pickup date, and creates the bill in QuickBooks Online for the rest:
Invoice 7731, load 51904-22816. Linehaul $3,100.00 and fuel $520.00 match the rate confirmation. Detention $175.00 cleared from Turvo stop times: appointment 6:00 AM, out 10:30 AM, 2 hours free, $70 an hour. Lumper $245.00 cleared against receipt R-40917. TONU $200.00 disputed by Ana Brooks in Slack, Nov 11, 9:42 AM: pickup was booked for Nov 5.
The flow also attaches the invoice and the lumper receipt to the load in Turvo and adds the approved detention and lumper to the customer’s charges, so the shipper is billed for both. Then it marks the load Ready for billing.
An invoice whose accessorials all check out becomes a bill without anyone opening it. Every run keeps a step-by-step record of what the flow checked and who decided.
Invoices come in through Gmail, and the stop times and documents come from Turvo. The rep answers in Slack, and bills go to QuickBooks Online.
Common accessorial charges and the evidence behind them
The terms in the last column are typical examples, not market rates. Your rate confirmations set yours. On free time, Truckstop’s accessorial guide says most carrier agreements give two free hours at each facility before detention starts.
| Charge | What it is | Evidence that proves it | Typical rate con term (example) |
|---|---|---|---|
| Detention | The driver waits past free time at pickup or delivery | Arrival and departure times against the appointment, from the TMS or stamped on the BOL or POD | 2 hours free, then $50 to $75 an hour, from the later of arrival or appointment |
| Layover | The truck is held overnight and delivers the next day | Stop times showing the truck was held into the next day | A flat amount per day, such as $250 |
| Lumper | A third-party crew unloads the trailer for a fee | The lumper receipt with the facility, date, load or PO number, and amount | Reimbursed at cost with a receipt |
| TONU | Truck ordered, not used: the truck was dispatched and the load canceled or not ready | A cancellation on the load, or the rep’s confirmation | A flat amount if canceled after dispatch, such as $150 to $250 |
| Driver assist | The driver loads or unloads the freight | A note on the BOL or POD signed by the facility | A flat amount, agreed before pickup |
How to check an accessorial before you pay it
- Read what the charge claims happened, where, and when.
- Find the term on the rate confirmation. A charge with no agreed term goes to the rep.
- Pull the evidence: stop times, the receipt, or the load’s status.
- Do the math with the rate con’s terms. For detention that means free time, when the clock starts, the hourly rate, and any cap.
- Clear what the evidence proves, and send the rest to the rep on the load.
- Tell billing which charges you approved, so the shipper is billed for them under the customer contract.
- Keep the evidence with the bill.
Step 6 matters because a broker sits in the middle of every accessorial. Detention you pay the carrier and never bill to the shipper comes straight out of your margin on the load. For the base audit of linehaul, fuel, the POD, and duplicates, see freight invoice audit.
Exceptions and what the flow does
| Exception | What it looks like | What the flow does |
|---|---|---|
| Late driver billing detention | Arrived 50 minutes after the appointment, billed 2 hours of detention | Checks your rate con’s rule for late arrivals and asks the rep, with both times |
| No stop times in the TMS | The driver never checked in or out in the app | Reads the in and out times stamped on the POD, or asks the carrier for them |
| Lumper with no receipt | A $245 lumper line and nothing attached | Looks for the receipt on the load in Turvo, and if none is there, asks the carrier for it in their email thread and holds that line |
| Layover with a same-day delivery | Layover billed, but the truck left the receiver that afternoon | Asks the rep, with the departure time |
| Billed twice | Detention on the invoice and again on a separate invoice a week later | Finds the earlier bill and stops the second charge |
Brokers and 3PLs can see the rest of what a flow handles on the logistics page.
How to start
Start with detention and lumpers. Their evidence is already on the load or attached to the invoice, so the flow can clear them without asking anyone.
For the first two weeks, send every TONU and every charge without a rate con term to the rep. Then set the amounts you approve without a question, carrier by carrier, from what your reps approved.
Frequently asked questions
What are accessorial charges in trucking?
Accessorial charges are fees a carrier bills on top of linehaul and fuel for extra time or work on a load. Detention, lumper, TONU, and layover are the ones a truckload broker sees most. Each one should be agreed on the rate confirmation and backed by evidence before it is paid.
What is a TONU charge?
TONU stands for truck ordered, not used. The carrier bills it when a truck is dispatched for a load that is then canceled or not ready, and the rate confirmation sets the amount and the cutoff after which it applies. Before paying it, confirm the load was actually canceled or refused after that cutoff.
Who pays the lumper fee?
The driver pays the unloading crew at the dock, and the carrier bills that amount back on its invoice with the lumper receipt. In brokered truckload the broker reimburses the carrier at cost under the rate confirmation and bills the shipper under the customer contract. No receipt, no reimbursement.